Oramask 831 topcoat spraypaint problems - Shapeoko - Carbide 3D

I recently carved a squadron badge for a friend and it was my 1st time using the method of paint then lay down vinyl then carve then paint the carved area then peel the vinyl. I used Oracal 631, I was very pleased with the way that it carved. I used a quarter inch down cut bit an 8th inch down cut followed by a 60ﾟ V bit and it cut beautifully. I had spray painted white then carved it then I spray painted black on top of the vinyl and carved areas, I sprayed 3 Coats of Rest oleum 2X satin spr

Help with vCarving a sign - Shapeoko - Carbide 3D Community Site

My Carbide 3D

Community challenge #24: Elements (closed) - Contests - Carbide 3D Community Site

Oramask 831 topcoat spraypaint problems - Shapeoko - Carbide 3D Community Site

Oramask 831 topcoat spraypaint problems - Shapeoko - Carbide 3D Community Site

Cash Only Signage - Gallery - Carbide 3D Community Site

Community challenge #24: Elements (closed) - Contests - Carbide 3D Community Site

My Carbide 3D

Help with finish machining - Shapeoko Pro - Carbide 3D Community Site

Oramask 831 topcoat spraypaint problems - Shapeoko - Carbide 3D Community Site

Community challenge #24: Elements (closed) - Contests - Carbide 3D Community Site

My Carbide 3D

Always learning1 1/2 inch facing tool on aluminum - Shapeoko - Carbide 3D Community Site

Help with proper bit selection - Shapeoko - Carbide 3D Community Site

My Carbide 3D