New, patch Adhesive 6-pack Industrial Strength Bond, Backing for

4.6

(83)

Write Review

$ 6.99

Add to Cart

Qty

In stock

Description

Need to apply iron-on backing to your patches? Applying adhesive to the back of your patches just got easier Our patch bond is sure to do the trick. 6 - 12x10 sheets Be sure to place a Teflon sheet on your heat press pad (protecting the padding from any glue or residue) Step 1: Lay patch on
Need to apply iron-on backing to your patches? Applying adhesive to the back of your patches just got easier Our "patch bond" is sure to do the trick. 6 - 12"x10" sheets Be sure to place a Teflon sheet on your heat press pad (protecting the padding from any glue or residue) Step 1: Lay patch on top of "patch bond" sheet, glue side up (shiny side -- has no adhesive) Step 2: Place 2nd Teflon sheet on top of your patch Step 3: Press your adhesive onto the patch 360 temp/ 7 seconds Step 4: Remove from pad Step 5: Let patch cool for approximately 5 minutes Step 6: Remove patch from Teflon sheet; remove backing paper and excess "patch bond" from your patch Step 7: Press patch onto your garment These same steps can be followed using an iron * no steam * Have fun! Patch Party Club EXCLUSIVE

Adfors FibaTape Wall and Ceiling repair patches are the ideal solution for repairing holes in drywall or plaster. The perforated aluminum patch and fiberglass reinforcement layer provide added strength for a permanent repair. The self-adhesive design allows for easy installation and finishing. Patches can be used on walls or ceilings and will not sag or rust.