PG Material only cuts on left side, crumb tray uneven? - Community Support - Glowforge Owners Forum

I received my Glowforge on Friday, 11/13/20 and put it together while following the instructions carefully. I have found that only the left side of the laser will cut all the way through, even on proof grade material. The right side will not cut through all the way, and even the engraving is inaccurate. As you can see in the picture below, I did do the “Gift of Good Measure”. I ran this on the left side as my first print and I thought it came out well. So then I printed a full sheet of my own d

Cleaning the Glowforge 3D Laser Printer

CutwoodCo

Cleaned machine, NOW it's not cutting through - Community Support

Santa Barbara Independent 10/19/23 by SB Independent - Issuu

CutwoodCo

PG Cherry Not Cutting or Engraving Properly - Community Support

Problems cutting through materials all the way - Beyond the Manual

Friendliest Glowforge Group on Facebook

Glowforge not cutting in one corner of the bed

Problem with proof grade cut and flashback marks - #22 by lester