Novice Mistake: Don't use a metal scraper on your FEP VAT : r/3Dprinting

Novice Mistake: Don't use a metal scraper on your FEP VAT : r/3Dprinting

What's causing occasional misprints like this? : r/ElegooMars

Tear in bottom of vat film, is the machine salvageable or a write off? : r /AnycubicPhoton

Clean failures off your FEP with ZERO SCRAPING! This is the best way!

Scratched my build plate with my first print. Is this real bad? I used the provided metal scraper to scrape the parts off. : r/ElegooMars

Pausing prints? So I'm 90% this print failed where I pressed pause to check if it had adhered to the build plate. Everything I've seen suggests pausing to check it. The fail

Yesterday I received my Photon Mono 4k and this happens when I try to print. It looks like it is the first layer but it gets stucked in FEP and nothing gets

The complete and utter idiots guide to 3D printing in resin for Wargamers - Wargaming3D

Fucked up by using IPA and paper towels to clean the FEP film after first print. Is this to scratchy/cloudy to use anymore? : r/AnycubicPhoton