Why first layer scan didn't stop the print? - Troubleshooting

I’m new to X1C and this is my 6 print. So far all prints looked pretty good but on this print it starting to fail. It printed the first layer and I got the dialog that says scanning first layer and once it finished it continued printed. As you can see from the results of the first layer, I would have expected it to stop. Is there something wrong with the printer or should I have done something different? Also, if anyone have suggestions to why the print came out that bad, it would be greatly ap

Print Quality Guide Simplify3D Software

I've had this issue with many prints, where the first layer is

PETG Issues - Bambu Lab X1 Series - Bambu Lab Community Forum

I've had this issue with many prints, where the first layer is

Any idea what causes this pilling and mess on the first layer

I just got my first printer and can't stop watching it print …how

3D printing First Layer issues troubleshooting Guide

Troubleshooting 3D prints, first layer issues

Scanning offset problems - LightBurn Software Questions

First layer problem with loose strings – Assembly and first

Built the machine, but when I do the first layer calibration it