Engraving paper - Ortur Lasers - LightBurn Software Forum

Hello, I’m trying to make earring cards with text engraved on it and sometimes it engraves okay, other times it’s missing chunks of letters. This was my very first try and it went perfectly! It was subtle enough and looked really good! Next, it didn’t go so well. I tried engraving 4x with the same settings and you can see what’s wrong. Then I also tried all the other settings, but I can never get it the same as on the first picture. It either looks too dark and burned too deep or it miss

Laser runs but does not engrave - Ortur Lasers - LightBurn Software Forum

Newbie here. Imported art in LightBurn does not match the engraving - Community Laser Talk - LightBurn Software Forum

Ortur laser master 3 cutting problems - Ortur Lasers - LightBurn Software Forum

Low Cost Chinese Laser Engraver For Marking Wood Projects in General Woodworking

Burning grid to base board? - Ortur Lasers - LightBurn Software Forum

Multiple Layers Shifted and Jogging - LightBurn Software Questions - LightBurn Software Forum

Laser connected and working but not engraving - Ortur Lasers - LightBurn Software Forum

Engraving detail please help - Ortur Lasers - LightBurn Software Forum

ORTUR LaserMaster 2 - image shrinks at start - Getting Started With LightBurn - LightBurn Software Forum

Ortur laser stops engraving, software issue? - LightBurn Software Questions - LightBurn Software Forum

Image and line trace engraving will not align. Help - Ortur Lasers - LightBurn Software Forum

Engraving starts going completely black - Ortur Lasers - LightBurn Software Forum