If I set LightBurn to Current Position and then set the Job Origin to anything but the lower left corner, the machine frames in the wrong place. It always frames as if it were starting from Current Position but with the Job Origin in the lower left corner. I’m using a 22W Creality Falcon 2. I’m using G-Code files instead of a USB connection. Below is a picture of a scrap piece of cardboard I was running tests on to figure out alignment. You can see my pencil marked X, whcih I was trying to hit
Creality CR-Laser Falcon 10W Laser Engraver, Higher Accuracy DIY
【Powerful Laser Cutter】With 10W output power, CR-Laser engraver can cut through 12mm wood board with one pass at a speed up to 10000mm/m. Even
10W Laser Engraver, Official Creality CR-Laser Falcon 72W Engraving & Cutting Machine, 0.06mm High Precision Laser Cutter for Cardboard, Wood
Solved - Creality Falcon 2 Win 7 cannot connect - LightBurn
Cr-Laser Falcon Owners and Support
Error:20 Unsupported or invalid g-code - LightBurn Software
Creality Official Laser Rotary Roller, 360° Laser
Error:20 Unsupported or invalid g-code - LightBurn Software
Laser Everything! Creality Falcon2 Review & Setup Guide with
Misalignment between the trace and the actual laser - GRBL
Creality CR-Laser Falcon 10W Laser Engraver, Higher Accuracy DIY
Creality CR-Laser Falcon 10W Laser Engraver, Higher Accuracy DIY
Laser on when framing problem - Community Laser Talk - LightBurn
Creality falcon 2 not connecting - GRBL - LightBurn Software Forum
Why doesn't light burn connect to my Creality Falcon 2 22w laser