Let it Flow Disney Wine HTV and Sublimation Prints, Disney Elsa

(393)

Write Review

$ 2.00

Add to Cart

Qty

In stock

Description

Iron on instructions are as follows: HTV:1.Preheat press to 300 degrees (iron/polyester settings for home iron).2.Preheat garment for about 5 seconds.3.Remove backing and place sticky side on garment.4.For best result check placement before pressing and cover with parchment paper or teflon sheet.5.Press for 15 seconds
Iron on instructions are as follows: HTV:1.Preheat press to 300 degrees (iron/polyester settings for home iron).2.Preheat garment for about 5 seconds.3.Remove backing and place sticky side on garment.4.For best result check placement before pressing and cover with parchment paper or teflon sheet.5.Press for 15 seconds with medium pressure (with iron- lift and move to next area).6.Wait about 5 seconds and peel warm. 7.Press again for 5 seconds.SUBLIMATIONSublimation transfer ready to press. You will only receive print. Images are printed on 8.5 x 11 inches and will be as big as the page allows. Please send us a message if a different size is needed. Sublimation transfers must be used on garments with at least 50% polyester count and the higher the polyester the better the image will look. The best recommendation is 100% polyester or sublimation blanks. WILL NOT WORK ON DARK COLORS. Sublimation transfer will only show on light colors.Print is reversed when printing but will look accurate after pressed. Image may look faded on the page but will be bright and vivid after pressing. Home irons are not recommended for pressing. For best results please use a heat press. HEAT PRESS SETTINGS: 390 degrees for 40 seconds. ****From personal experience- please lint roll your garment before pressing to remove all dust and debris, otherwise, it will press into your garment as well.****