Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum

Hello, I read lots of posts regarding Circles not round and do not meet but couldn’t see the same issue I experience. I am new to laser cutting and just assembled a Sculpfun S30 Pro (10W) with Y axis extension. When engraving / cutting the first test pattern, the cut circles are oval and there are strange lines off the circles (and rectangles too). I run some additional tests just on the cutting after adjusting the Y axis belt, but it made no difference. I then used LaserGRBL to make t

Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum

Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum

Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum

Using offset circle with fill - nothing seems to happen but preview looks fine - LightBurn Software Questions - LightBurn Software Forum

Circle trouble - beginning and end are offset - LightBurn Hardware Compatibility - LightBurn Software Forum

Circles not round - LightBurn Hardware Compatibility - LightBurn Software Forum

Atamstack A5 Pro+ will not jive with lightburn - LightBurn Hardware Compatibility - LightBurn Software Forum

Critical issue with new version 1.2.01 -- OFFSET + file compatibility - LightBurn Software Questions - LightBurn Software Forum

Kerf (cutting offset) Issues - LightBurn Software Questions - LightBurn Software Forum

Edges/offsets in circles depending on it's starting point (backlash?) - LightBurn Hardware Compatibility - LightBurn Software Forum

Cutting circle issue - LightBurn Software Questions - LightBurn Software Forum

Offset Shape not working - LightBurn Software Questions - LightBurn Software Forum

Full Lightburn Control Guide - Snapmaker 2.0 - Snapmaker: where creation happens