Stewart-MacDonald #3215 - StewMac Buffing Wheels, 14 Canton, 1 Shaft 2020

StewMac - StewMac Buffing Wheels, 14 Canton, 1 shaft The right domet and canton flannel cotton buffing wheels for scratch-free guitar finishing with a buffing arbor.

StewMac Buffing Wheel, 14 Canton, 1 Shaft

Before purchasing the Parma system, I had used a buffing system from Stewart -McDonald. It was a very good buffer but its' shaft length was just too short unless you were buffing the body and neck separately.

Motor for Buffing ArborThis 3/4-horse motor has the power to drive our Guitar Buffer: those large buffs contact a lot of surface area, and this motor is up to the job.Runs at the right speed, turning the buffs at 715-rpm ideal for delicate instrument finishes.1725 rpm60 Hz3/4 horsepowerIncludes 1.89 pulley#3083 Motor is for domestic use. This 120-volt AC electrical appliance has a U.S. standard Type B plug with two flat parallel prongs and a grounding pin. 6.2 amps, 550 watts.

StewMac Motor for Buffing Arbor, Domestic, 120-Volt Buff 3083

Polishing - Buffing Wheels - Page 1 - Caswell Inc

StewMac Buffing Wheels, 12 Canton wheel for 3/4 shaft

Rubberized ceramic wheels give your fret jobs that mirror shine and ultra-smooth feel players love Faster and easier than hand polishing Mount the

StewMac Fret Polishing Wheels, Complete Set

Buffing and Polishing Supplies - StewMac

Fret Polishing Wheels - StewMac

DYI Guitar Buffing Wheel - Sandmon Guitars