BSI FOAM-CURE (4OZ) – Flex Innovations

BSI FOAM-CURE (4OZ) – Flex Innovations

4.5
(485)
Write Review
More
$ 9.00
Add to Cart
In stock
Description

Bob Smith Industires' FOAM-CURE™ is a silicone-based adhesive that works very well on EPP and EPO foams. It is crystal clear and cures to a more flexible consistency than CA. It is, however, not instant bonding like CA and there is no accelerator to speed it’s curing. To obtain a faster initial bond when bonding two pieces, FOAM-CURE™ can be applied to one piece and after the two are joined, they can then be pulled apart. After letting it air dry for about ten minutes, FOAM-CURE™ will act like a contact cement when the parts are rejoined, resulting in enough tack strength to allow the next steps of assembly. Full strength is reached in 10-12 hours. FOAM-CURE™ works with all foams, and will actually bond most other materials. It will bond wood and plastic to foam, and is a good canopy glue. FOAM-CURE™ does not, however, cure flexible enough to act as a hinge for aircraft control surfaces. Its limitations occur when bonding large areas of two non-porous materials. FOAM-CURE™ requires exposure to air for drying. If one tried to bond, for example, a half-dollar coin to glass, over 90% of the adhesive would never cure, since the solvent it contains would have no where to evaporate. A small amount of denatured alcohol can be mixed into the Foam-Cure to make it thinner.

Odorless CA Super-Gold+ Cyanoacrylate

Bob Smith Industires' FOAM-CURE™ is a silicone-based adhesive that works very well on EPP and EPO foams. It is crystal clear and cures to a more

BSI FOAM-CURE (4OZ)

Bob Smith Industries BSI-142 Clear Foam-Cure, Craft Glue, 4 oz.: : Industrial & Scientific

Bob Smith Foam-Cure Craft Glue 4oz (BSI-142) – Friendly Hobbies

Bob Smith Industries BSI-142 Clear Foam-Cure, Craft Glue, 4 oz.: : Industrial & Scientific

INSTA-SET is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization. INSTA-SET in a spray bottle is normally used to cure the CA that flows from joints when parts are pressed together. Applying an additional bead of thick CA along a seam and then curing it with INSTA-SET significantly enhances a joint?? s strength.

Foam-Cure 4 Ounce Glue

Bob Smith Industries 141 Foam Cure, 1 oz : Arts, Crafts & Sewing

Maxi-Cure, Super Glue

Foam-Cure Flexible Clear Silicone Glue 4oz Bottle Bob Smith Industries